Channel tubing provides strong, clean look

Share This Article

  • Del.icio.us
  • Digg
  • Facebook
  • Google Bookmark
  • StumbleUpon
  • Technorati
  • Twitter

H2Ube from Morse Industries incorporates two channels within an extruded anodized aluminum tube, providing a stronger, tighter and cleaner look for canvas applications. With H2Ube, a common welt is sewn to the finished edge of the canvas. Special notches in the tube allow the welt to be inserted and slid through, resulting in less labor and materials by eliminating the use of pockets. H2Ube wall thickness is over twice that of standard tubing, and it can be bent up to a 4-inch radius without the channel collapsing. Each length has a feeder machined into the tubing, allowing the use of traditional hardware.

SOURCE Morse Industries, 800 325 7513

Comments

There are not yet any comments.
You can submit a comment using the form below.


Submit a Comment

Required. Will appear next to your comment.
Required. Will not be displayed on site or used to send unsolicited messages.
If applicable. A link to your site will appear with your comment.
Optional. Will appear in bold type above your comment.