This page was printed from https://marinefabricatormag.com

Cutting system built for use on various materials

September 1st, 2008 / By: / Equipment

The Advanced Performance Compression Cutting System from Dehnco combines compression cutting technology with precision linear motion for straight cuts with no threading or rough edges. A rotary blade enclosed in the cutter housing cuts in both directions. The machine retains the leading edge of the material for easy access, and multiple materials can be loaded into the cutting system simultaneously.

The Advanced Performance Compression Cutting System can be used on canvas, vinyl, fiberglass, cloth, foam, rubber, natural and synthetic fibers, and woven and nonwoven materials. The system has a cutting capacity of up to 100 inches and can be table-mounted or freestanding. Pneumatic drive systems are available.

SOURCE Dehnco

Leave a Reply

Your email address will not be published. Required fields are marked *

Comments are moderated and will show up after being approved.