This page was printed from https://marinefabricatormag.com

Software converts 3-D models into drawings and cut files

July 1st, 2009 / By: / Accessories

TouchCAD 3D modeling software converts complex three-dimensional models into drawings and cut files ready for production. Preparation for production is included in the design process to increase efficiency, rather than treating the processes as two separate acts. Push-pull techniques with integrated unfolding and unwrapping features are used in the software.

SOURCE TouchCAD

Leave a Reply

Your email address will not be published. Required fields are marked *

Comments are moderated and will show up after being approved.